20

2021

-

04

Brief introduction of the production process of dipped gloves

Author:


dipped gloves have high dexterity. It is comfortable to wear and has high strength. The pinhole rate is low. Has excellent sealing protection characteristics. What is its production process?

First, the rubber is sliced through a rubber mixer. Then send the sol tank to mix sol with gasoline. After the sol is emulsified and prepared, it is pumped to the latex intermediate tank. The rubber solution dissolved in gasoline is fed from the top of the distillation tower. Distilled by steam heating. The light component gasoline is heated into a gas phase. The gasoline gas is mixed and cooled by cold water in the oil-air cooler. The oil-water mixture goes to the oil-water separator. Upper gasoline recovery. The lower water is then pumped to the cooling tower for cooling. After cooling, the gas gasoline in the distillation tower is cooled. The latex of the distillation tower kettle is sent to the latex mixing tank for stirring according to its own pressure, and after preparation, it is sent to the centrifuge to separate the glove raw latex. After toning and filtering, set aside.

The glove model is first cleaned with acid and alkali and washed with water. The cleaned model is first immersed in hot water and heated until it is soaked with coagulant and dried for dipping. After dipping, it is sent to the oven for preliminary drying, adding fiber inner sleeve, flushing hot water and then sending to the oven for vulcanization, drying and forming. After the gloves are demolded, they are checked for inflation, low-temperature setting, medium-temperature drying, washing, dehydration, drying and packaging. Send to finished product warehouse immediately.

Prev

Next

undefined

undefined